A carbon fiber tiller extension built to fit Evinrude ETEC outboard motors. Easy to install and remove. You do not have to modify the motor for installation. A remote switch for tilt and trim (if applicable) or jack-plate is available. We drill a 1" hole into the top of the TillerPillar to allow for access to the factory tilt switch.
The listed length is for the overall length of the TillerPillar, including the area that slides over your existing grip. Measure from the largest circumference of the grip; the portion closest to the cowling.
IMPORTANT: Please verify the rubber grip on your motor matches the rubber grip in the first picture on this page. If you have any questions as to which TillerPillar model you should order, please send an email to email@example.com with a picture of your rubber grip and we would be more than happy to assist you.